LPC-L2294 DEVELOPMENT PROTOTYPE BOARD WITH 8MB SRAM, 4MB FLASH, CAN, RS232, ETHERNET, SD/MMC

fs

FEATURES:

• MCU: LPC2294 16/32 bit ARM7TDMI-S™t with 256K Bytes Program Flash, 16K Bytes RAM, EXTERNAL MEMORY BUS, RTC,4x 10 bit ADC 2.44 uS, 2x UARTs, 4x CAN, I2C, SPI, 2x 32bit TIMERS, 7x CCR, 6x PWM, WDT, 5V tolerant I/O, up to 60MHz operation
• standard JTAG connector with ARM 2x10 pin layout for programming/debugging with ARM-JTAG
• 1 MB (256K x 32 bit) fast 10 ns K6R4016V1D SRAM or 8MB (2Mx32bit) 70 ns K1S321611 SRAM
• 2MB (1MB x 16bit) 70ns TE28F160C3BD70 or 4MB (2Mx16bit) 70ns TE28F320C3BD70 C3 INTEL FLASH
• Ethernet controller with CS8900A and RJ45 connector (16bit mode with interrupt)
• RS232 port
• UEXT connector
• CAN drivers and connector
• SD/MMC card connector
• all LPC2294 port signals available on extension coonectors
• RESET circuit with exterman control of Philips ISP utility via USB-RS232 virtual port
• Jumpers for boot select from external memory
• Jumpers for ISP/RUN mode
• 1 user button
• RESET button
• two on board voltage regulators 1.8V and 3.3V with up to 800mA current
• FR-4, 1.5 mm, red soldermask, component print
• Dimensions: 118 x 101 mm ( 4.65 x 3.97")

DOCUMENTS:

• LPC-L2294.pdf

• LPC-L2294-1MB schematic
• LPC-L2294-8MB schematic

• Native hardware support by eCOS the anonymous eCos CVS tree has this target inside 'olpcl2294' eCos target . Here is the link to eCos 3.0 the anouncement . The instructions how to install eCos 3.0 on Linux and Windows
• BLINK LED project for GCC+OpenOCD+ECLIPSE
• OpenBLP BOOTLOADER - quick guide how to install a very neat bootloader by Frank Voorburg
• GCC+Eclipse+OpenOCD uIP complete project
• OpenOCD + Eclipse set of projects 1.00 include flash write make file for LPC-L2294. The complete list of projects included is here.

ORDERING CODES:
		LPC-L2294-1MB - assembled and tested board, includes LPC2294 microcontroller, 1MB fast SRAM, 2MB FLASH
		LPC-L2294-8MB - assembled and tested board, includes LPC2294 microcontroller, 8MB SRAM, 4MB FLASH