LPC-E2294 DEVELOPMENT PROTOTYPE BOARD WITH USB, 4x CAN, RS232, ETHERNET

OBSOLETE BOARD - PLEASE CHECK LPC-E2294-1MB REV.B

FEATURES:

• MCU: LPC2294 16/32 bit ARM7TDMI-S™t with 256K Bytes Program Flash, 16K Bytes RAM, EXTERNAL MEMORY BUS, RTC,4x 10 bit ADC 2.44 uS, 2x UARTs, 4x CAN, I2C, SPI, 2x 32bit TIMERS, 7x CCR, 6x PWM, WDT, 5V tolerant I/O, up to 60MHz operation
• standard JTAG connector with ARM 2x10 pin layout for programming/debugging with ARM-JTAG
• 1MB (256Kx32bit) 12 ns 71V416 SRAM
• 4MB (512Kx16bit) 70ns TE28F320C3BD70 C3 INTEL FLASH
• USB to RS232 convertor, board can take power only from USB port
• 4 CAN drivers and connectors
• RESET circuit with exterman control of Philips ISP utility via USB-RS232 virtual port
• Jumpers for boot select from external memory
• Jumpers for ISP/RUN mode
• Ethernet controller with CS8900A and RJ45 connector
• LCD 16x2 DISPLAY with BACKLIGHT
• 2 BUTTONS
• POTENTIOMETER connected to AIN0
• SPI connector
• RS232 driver and connector
• DALLAS i-BUTTON interface and connector
• I2C 24LC515 EEPROM on board
• two on board voltage regulators 1.8V and 3.3V with up to 800mA current

DOCUMENTS:

• LPC-E2294.mht
• LPC-E2294.chm

• LPC-E22xx Schematic

• test software and basic routines for access to the external Flash/Sram
• Native hardware support by eCOS the anonymous eCos CVS tree has this target inside 'olpce2294' eCos target
• Ethernut OS port for LPC-E2294 made by Michael Fischer
• RS232 initialization
• RTC initialization
• LCD test code
• button test code
• trimpot read code
• EEPROM read/write code
• Dallas iButton code
• CS8900A ID read code
• OpenOCD + Eclipse set of projects 1.00 include flash write make file for LPC-E2294. The complete list of projects included is here.

ORDERING CODES:
		LPC-E2294 - assembled and tested board, includes LPC2294 microcontroller, 1MB SRAM, 4MB FLASH