ADuC-IO7020 DEVELOPMENT BOARD FOR ADuC7020
ARM7 MICROCONTROLLER

INFO:
ADuC-IO7020 is very good platform for automation application which need fast
ADC and DACs and need to commutate high loads. It have 4 relays 240VAC/10A,
4 optoisolated inputs, RS232, JTAG and the 1Msps ADC/DACs are available on separate
conenctor for connection to external sensors.
FEATURES:
- MCU: ADuC7020 - ARM7TDMI Core, 16/32-bit RISC architecture, 5 Channels
12-bit, 1MSPS ADC, Differential and single-ended modes, 0 to Vref Analog Input
Range, 4 Outputs 12-bit Voltage Output DACs, On-Chip 20ppm/°C Voltage
Reference, On-Chip Temperature Sensor (±3°C), Uncommitted Voltage
Comparator, JTAG Port, Clocking options: Trimmed On-Chip Oscillator (±
2%), External Watch crystal, External clock source
45MHz PLL with Programmable Divider, 62k Bytes Flash/EE Memory, 8k Bytes SRAM,
In-Circuit Download, JTAG based Debug, Software triggered in-circuit re-programmability,
UART, dual I2C and SPI Serial I/O, 14-Pin GPIO Port, 2 X General Purpose Timers,
Wake-up and Watchdog Timers, Power Supply Monitor, PLA Programmable
Logic (Array), Power Specified for 3V operation, Active Mode: 6mW (@1MHz)
300mW (@45MHz), Fully specified for 40°C to 85°C operation;
- JTAG connector for in-circuit programming and debugging with ARM-JTAG
- RS232 interface circuit and connector
- I2C connector
- RESET button
- SERIAL DOWNLOAD (bootloader enable) button
- LED status
- power supply circuit with plug-in power jack and diode protection
- 32 768 Hz oscillator crystal
- 4 RELAYs with 10A/250VAC NO and NC contacts with screw terminals
- extension header for ADC and DAC ports
- PCB: FR-4, 1.5 mm (0,062"), green soldermask, white silkscreen component
print
- four mounting holes 3.3 mm (0.13")
DOCUMENTS:
HARDWARE:
SOFTWARE:
ORDERING CODES:
ADuC-IO7020 Completely assembled and tested
Click here for our PRICELIST and shipping
options, and click here to learn HOW
TO ORDER